Three-tier single card display (digital download)

$6.00

Have your own laser engraver? These are the SVGs I use for my jewelry displays. It comes with my logo at the top so you can see the size and format I use, but feel free to swap it with your own logo or leave it blank!

This display is put together WITHOUT glue! the pieces simply slide in together. They fit pretty tight so it won’t fall apart on you. I’d recommend getting a 1 lb dead-blow hammer from a hardware store to help you fit the shelves into the back.

This file is for use with 1/4 inch thick materials.

This is a DIGITAL DOWNLOAD only. If you would like to purchase a physical jewelry display, visit the Jewelry Displays page.

Have your own laser engraver? These are the SVGs I use for my jewelry displays. It comes with my logo at the top so you can see the size and format I use, but feel free to swap it with your own logo or leave it blank!

This display is put together WITHOUT glue! the pieces simply slide in together. They fit pretty tight so it won’t fall apart on you. I’d recommend getting a 1 lb dead-blow hammer from a hardware store to help you fit the shelves into the back.

This file is for use with 1/4 inch thick materials.

This is a DIGITAL DOWNLOAD only. If you would like to purchase a physical jewelry display, visit the Jewelry Displays page.

Specs:
Small end displays: 4” wide x 5” tall
Taller center display: 4” wide x 6” tall
1” deep shelves with 1 engraved groove for a single jewelry card per display


Glowforge pro settings:
Logo and small text (black) – 300 speed / 40 power
Shelf grooves (blue) – 300 speed / 100 power
Cuts (red lines) – 117 / full power

*Note that these are the settings for my glowforge with my 1/4 inch double-sided wood veneer materials. Depending on your machine and your materials, settings may need to be altered so be sure to do a test print before printing your final product!

You Might Also Like