3-inch necklace stand (digital download)

$4.00

Have your own laser engraver? These are the SVGs I use for my jewelry displays.

This display is put together WITHOUT glue! the pieces simply slide in together. They fit pretty tight so it won’t fall apart on you. I’d recommend getting a 1 lb dead-blow hammer from a hardware store to help you fit the upright piece into the base.

This file is for use with 1/8 inch thick material for the upright portion, and 1/4 inch thick material for the base.

This is a DIGITAL DOWNLOAD only. If you would like to purchase a physical jewelry display, visit the Jewelry Displays page.

Have your own laser engraver? These are the SVGs I use for my jewelry displays.

This display is put together WITHOUT glue! the pieces simply slide in together. They fit pretty tight so it won’t fall apart on you. I’d recommend getting a 1 lb dead-blow hammer from a hardware store to help you fit the upright piece into the base.

This file is for use with 1/8 inch thick material for the upright portion, and 1/4 inch thick material for the base.

This is a DIGITAL DOWNLOAD only. If you would like to purchase a physical jewelry display, visit the Jewelry Displays page.

Specs (upright portion):
3” wide x 4.25"” tall

Glowforge pro settings:
Upright piece (1/8 inch thick): Cuts (red lines) – 170 speed / full power
Base (1/4 inch thick): Cuts (red lines) 117 speed / full power

*Note that these are the settings for my Glowforge with my 1/4 inch double-sided wood veneer materials. Depending on your machine and your materials, settings may need to be altered so be sure to do a test print before printing your final product!